Top-rated toilet pros.

Get matched with top toilet pros in Hamlet, NC

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Hamlet, NC?

Select your specific project to find the pro for you.

TRUSTED BY HAMLET, NC HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon89
    Verified toilet services reviews

Find Toilet pros in Hamlet

Avatar for Pride Plumbing
Pride Plumbing
4.8(
9
)

Serving Hamlet, NC and surrounding areas

Approved

In business since 1965

Free estimates

Emergency services offered

"Did a good job but could have cleaned up a little better. Didn't have everything needed for job on truck and had to return to shop to get seat. Has an $89 charge to come out for quote that wasn't mentioned beforehand."
We install and service water filtration and water treatment systems.
We pump septic tanks.
We install Jacuzzi tubs.
We dig trenches for yard repipes and to uncover septic tanks.
We repair, test, and certify RPZ backflows.

+17

1 neighbors recently requested a quote
Recommended by77%of homeowners
Showing 1-10 of 39
Toilets questions, answered by experts

Toilet seats have two mounting brackets on the back that accept mounting bolts. The bolts drop through the brackets, through two small holes on the top of your toilet, and then receive nuts to hold them in place on the bottom of the toilet. If you can’t see the bolt heads, you might need to pry up the mounting bracket cover, which is a plastic piece that hides and protects the bolts.

You definitely can over-tighten toilet tank bolts. Unlike some other materials, porcelain can’t bend or flex, so when you over-tighten a screw into it, it could break against the added pressure. Only tighten them as much as needed to keep them in place and firm; any more and you could risk breaking the porcelain.

If you have to hold the toilet handle (also called the toilet lever) down to flush, you probably have a chain problem. A chain that cannot fully lift the flapper will close too early and not clear the toilet bowl. Try adjusting the chain length so there’s about ½ inch of slack.   

Many parts of your plumbing system can fail, but clogged drains are one of the biggest plumbing problems you’ll likely encounter. From your kitchen sink, bathroom sink, or bathtub, there are plenty of opportunities for gunk, hair, food scraps, and more to get stuck in drains. When this happens, water will slowly drain, leading to standing water, bad odors, drain flies, and other issues.

Many homeowners can handle a minor clog themselves, but if you have a clog in your main line, you’re best off hiring a local plumber to get the drain back to its normal flow rate.

The amount of water wasted when a toilet ghost flushes depends on the cause of the ghost flushing. Leaky flapper valves tend to waste less water than a larger problem like a damaged flush valve that makes the toilet run constantly. Even if you don’t think you’re wasting a lot of water, it’s still a problem that should be fixed quickly. 

The Hamlet, NC homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.