Best roofers near Glade Valley, NC

Rain shouldn’t come in through your ridge vents unless your vents are damaged or the rain is accompanied by very high winds. Most ridge vents use flashing or baffling to keep out rain, snow, and debris. If your ridge vent isn’t baffled, rain is more likely to enter your attic, so ridge vents with baffles are a better choice in areas with regular rainfall.

If you need to replace the roof over your attached garage, a roofing contractor can perform what is called a partial roof replacement that only affects garage roofing. However, it's important to keep in mind that only replacing a portion of your roof creates a situation where your roofing has two different lifespans. You will also miss out on the opportunity for a full roof warranty. In some cases, having two different roofs on your home could increase risks for leaks. When replacing the roof on a detached garage, homeowners have the option to make the project bigger by upgrading their home roof alongside their garage roof. However, this isn't necessary if your home has a newer, properly functioning roof. It is better to try to match the new garage roof to your home's existing roof instead.

As with any roofing material, there are benefits and drawbacks to consider before installing roll roofing. On the plus side, roll roofing is budget-friendly, lightweight, and comparatively easy to install. It is also ideal for low-sloped roofs and lasts around 10 years. The cons of roll roofing, however, include its low durability compared to roofing materials, restricted color choices, and low ROI.

Pros:

• Low-cost

• Lightweight

• Cut to size

• Easy and quick installation 

• Designed for low-sloped roofs

• Waterproofs your roof for an average of 10 years

• Easy to purchase and transport

Cons:

• Less durable than asphalt shingles

• More prone to cracks and tears

• Short life span

• Not as many color or style choices

• Not as aesthetically pleasing as shingles, wood, or clay tiles

• Not preferred for a higher home resale value

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.