Get matched with top flooring contractors in Four Oaks, NC

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

While it is possible to install carpet yourself, it is a challenging DIY project that requires precise measurement, proper cutting skills, and knowledge of correct installation techniques. The process involves multiple steps, including removing old flooring, installing underlayment and tack strips, and stretching the carpet to prevent wrinkles, which can take several days to complete.

Before starting, consider these factors:

• Warranty: Many manufacturers' warranties are voided if the carpet is not installed by a professional.

• Tools: You will need to buy or rent specialized equipment like a knee kicker, carpet stretcher, and seam roller.

• Complexity: DIY installation is most suitable for simple, straightforward rooms. Projects involving stairs or floor vents are significantly more difficult.

• Cost: While you can save on labor, the cost of tools plus the risk of expensive mistakes—which may require re-installation—can make hiring a professional more cost-effective in the long run.

Given the potential for errors, voided warranties, and the need for special tools, hiring a local carpet installer is often recommended to ensure the job is done correctly and safely.

For rooms with an even number of feet (10 x 12, for example), you can technically just multiply them together to get the number of square feet in the room (10 feet x 12 feet = 120 sq. ft.). For irregularly shaped rooms or areas that aren’t even square feet, converting to inches will be your best bet for an accurate measurement.

To prep a floor for painting, start by sweeping and cleaning any loose debris that could puncture the protective material. Take out as much furniture as possible. Then lay plastic, canvas, rosin paper, or masonite sheets across the room, securing them at the edges with masking tape. Plan your painting so that you minimize the chances you’ll step in and track any splatters.