Get matched with top roofers in Fleetwood, NC

Rain shouldn’t come in through your ridge vents unless your vents are damaged or the rain is accompanied by very high winds. Most ridge vents use flashing or baffling to keep out rain, snow, and debris. If your ridge vent isn’t baffled, rain is more likely to enter your attic, so ridge vents with baffles are a better choice in areas with regular rainfall.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

The installation may have been done correctly. However, improperly installed gutter guards can easily damage your shingles. Also, cheap gutter guards rarely come with installation fixtures. In the worst cases, they simply ask you to nail the guards in, which would sabotage your roof’s water resistance and thus void the warranty. To be sure, always check with your home warranty provider before making any modifications.

EPDM roofs have a few common problems, most of which can be resolved with regular maintenance. This type of roofing is laid down in sheets with seams, which can be a starting point for leaks. Proper installation and roof sealing can often avoid seam issues. 

The material is also susceptible to tears and punctures from falling branches or other sharp objects. There are black and white versions of EPDM, and the black version is more prone to fade and succumb to UV damage. Regular roof inspections can protect the costs of rubber roof installation and extend the life of your roof.