Get matched with top pressure washers in Conover, NC

It’s important to avoid power washing your house during freezing temperatures because the excess water can freeze on surfaces and cause damage. You should also avoid doing this task during heavy wind or rain because the water spray becomes less effective and could spread debris. Don’t power wash your home if your siding is cracked, loose, or peeling because the high pressure can worsen the damage. Lastly, if your home has delicate materials like softwood or stucco, consider gentler cleaning methods to prevent structural harm.

We don’t recommend pressuring washing clapboard siding. At high levels of pressure, a pressure washer can damage wood siding permanently. Pressure washing can also make it easier to drive water into the cracks of clapboard (which are recommended for easier drainage), causing moisture damage.

If you think your clapboard siding is so dirty it could benefit from pressure washing, we suggest contacting a pressure wash cleaning service and getting a quote on a wood siding project. Some siding manufacturers recommend never pressure washing because it can force water behind the siding.

Yes, a pressure washer uses less water than a garden hose. There are many ways to use a pressure washer, and it can be an eco-friendly hose substitute. While a pressure washer expels water with greater force, it uses 50% to 70% less water than a garden hose. Specifically, hoses put out six to 10 gallons per minute (GPM), while pressure washers only use two to five GPM.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.