Top-rated epoxy flooring pros.

Best epoxy flooring pros near Alliance, NC

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Alliance, NC?

Select your specific project to find the pro for you.

Top-Rated Epoxy flooring pros in Alliance - Updated Nov 2026

Avatar for C&A Remodeling
C&A Remodeling
4.9(
9
)
Concrete Floor Coating-Apply - For Business

Serving Alliance, NC and surrounding areas

In business since 2021

"Alex and his crew were fantastic. They came out and gutted my camper and installed new walls and floors. Super professional and wonderful craftsmanship."
Response time9 hrs
Response rate94%
Recommended by77%of homeowners
Avatar for 910 Concrete Coatings
910 Concrete Coatings
3.7(
15
)
Concrete Finishing, Overlays & Coloring - ApplyConcrete Floor Coating-ApplyConcrete Floor Coating-Apply - For Business

Serving Alliance, NC and surrounding areas

In business since 2017

Free estimates

Warranties offered

"I did a little homework and found that 910 concrete coating was the best choice reasonably priced offered same lifetime warranty as the other concrete coating businesses. Unfortunately, I was not able to upload photos because kept on getting a message that the file is too large and cannot be uploaded the maximum. File size is 5MB. Brandon was very attentive to our needs explained everything and was very professional. If you’re doing an epoxy floor in your lanai or your garage 910 concrete coatings is the way to go."
Garage floor application
Stain
Partial flake
Partial
Stain

+1

Response time10 hrs
Response rate90%
Showing 1-10 of 27
Epoxy Flooring FAQs, answered by experts

It depends on the type of sealer. Some sealers can dry in as little as 4 hours, but many can take up to 48 hours to fully cure. To play it safe, don’t drive on your driveway for two days after sealing.

If your concrete stains are green in color, it indicates the presence of mold or algae—which you should address right away. If left unattended, mold will spread to other areas throughout the home. However, be careful not to disturb mold on indoor concrete surfaces and work with a local mold remediation specialist for specialized care. Once free from mold and algae, seal your concrete to eliminate pores and gaps.

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

The Alliance, NC homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.