Best sump pump installation pros near Victor, MT

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

Thankfully, you do have a few sump pump backup options in case it fails. One option is a battery-powered backup sump pump. Another option is using a portable backup generator as a power supply for your sump pump. Unlike a battery-powered backup which has limited power, a generator can run around the clock for as long as you need it. 

Or you can opt for a water-powered backup pump, which uses your home’s water supply as a source of power. However, this may not be the best option if you find your house frequently has low water pressure.

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to move wastewater and solid waste to the municipal sewer or septic tank. However, for fixtures located below grade (e.g., in a basement), gravity is not sufficient.

The purpose of a sewage ejector pump is to actively pump this wastewater and solid waste upward into the main sewer line. Without an ejector pump in this situation, wastewater would have no way to exit and would eventually back up, causing a sewage overflow or flooding in your basement. If all of your home's plumbing is on the main floor or higher, gravity can handle the drainage, and an ejector pump is not needed.

To maintain your sump pump, start by checking it every three to four months to ensure it’s in working order. Clear any debris from the pit because blockages can prevent the pump from operating efficiently. You should also test the pump by pouring a bucket of water into the pit. If it turns on automatically and drains the water, it’s functioning correctly. Inspect the discharge line for clogs, and ensure it directs water away from your home. Once a year, clean the pump itself, and consider having it professionally serviced for optimal performance.