Top-rated floor polishers.

Get matched with top floor polishers in Terry, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Terry, MT?

Select your specific project to find the pro for you.

Find Floor polishers in Terry

No results for Floor polisher in

Try adjusting your search criteria.
Floor Polishers questions, answered by experts

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

You can regularly clean your Marmoleum® flooring by sweeping, vacuuming, and damp mopping with a neutral cleaner. Avoid using highly abrasive materials or high-pH cleaners to prevent cracking, warping, or discoloration, and never wet mop, as heavy water exposure can damage the floors. Marmoleum® floors have a topcoat called TopShield preinstalled, so you do not need to polish them.

After carpet removal, prepare for new flooring by assessing the subfloor. You will want to address any imperfections to create a smooth and level base for installation. Remember, proper subfloor preparation is crucial for optimal new flooring results. Consider repairing and replacing damaged areas for a stable foundation. For both wood and concrete subfloors, consider sanding to remove any debris or adhesives remaining thoroughly. 

Yes, you can mop hardwood floors with a damp flat or string mop as long as it is not soaking wet. Always avoid leaving standing water or fully soaking your hardwood floors, even if they are properly finished. A slightly wet mop, with or without cleaning solutions, will not damage the wood.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The Terry, MT homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles