Get matched with top toilet pros in Chester, MT

There are a few reasons why this could be the case. More than likely, your flapper is worn out and needs to be replaced. When it’s worn out, it lowers the water pressure during each flush leading to inefficient flushing. Luckily, replacing a toilet flapper is a simple repair that should only take about 30 minutes.

Emergency plumbers charge a significantly higher rate than for standard service, typically 1.5 to 3 times the normal hourly cost. You can expect to pay between $100 and $500 per hour, with an average of around $200 per hour. In addition to the higher hourly rate, many plumbers charge a flat emergency service or trip fee, which can be between $150 and $300. The final cost depends on the timing of the call; prices are highest for major holidays, followed by weekends and after-hours service on weekdays. For a complex job on a major holiday, a master plumber's rate could reach as high as $600 per hour.

It is okay to use a drain auger on a toilet, just make sure you are using the correct tip size. The auger is a plumbing snake with a protective sleeve to protect the porcelain toilet bowl from getting scratched. Using too large of an auger can cause the snake to loop back and damage the inside of the drain and plumbing.

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.