Top-rated toilet pros.

Get matched with top toilet pros in Browning, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Browning, MT?

Select your specific project to find the pro for you.

Find Toilet pros in Browning

AtWork4You
4.5(
2
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Browning, MT and surrounding areas

In business since 2010

Free estimates

Emergency services offered

We can help with general repairs, maintenance and upgrade to your home, be it outside tree trimming or your cellphone repair. We provide meticulous, honest and reliable service. We are well versed in all aspects of construction. Over 9 years of experience.

Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+25

Recommended by100%of homeowners
Avatar for TCH Builders & Remodeling
TCH Builders & Remodeling
4.0(
2
)
Faucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Browning, MT and surrounding areas

In business since 1999

Emergency services offered

Credit card accepted

If you dream it, we can build it. What's the biggest difference between us and them? We build to last! We offer a full line of Green and Energy Star Certified products, backed by our labor and manufacturer's lifetime transferable warranties. Credit Cards Welcome Financing Available OAC.

Recommended by100%of homeowners
Toilets questions, answered by experts

Yes, you should caulk a toilet to the floor for several reasons. Bathrooms are constantly wet—and if water splashes out of your shower and collects on your floor, you don’t want it seeping underneath your toilet, where it could potentially cause damage. Plus, caulk adds stability and helps prevent your toilet from wobbling.

Depending on the issue and materials, costs range from $150 to $500.

To drain a broken toilet, place towels or plastic sheeting around the base in case of splashing or overflowing. Next, shut off the toilet’s water supply, usually via a valve on the wall behind the toilet. Begin flushing the handle to remove as much water as possible from the tank and the bowl. Don’t flush the toilet if it’s clogged, though. From there, use a large sponge to soak up any remaining water and wring it over a bucket. 

Most toilets have a 12-inch rough-in or hole, but some have 10- or 14-inch holes, which means that not all toilets fit all setups. Knowing how to measure the rough-in is essential, so you purchase a toilet that fits the existing drain hole. It can be costly to have the rough-in moved, and most stores don’t accept toilet returns.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

The Browning, MT homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.