Get matched with top epoxy flooring pros in Broadus, MT

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Outdoor kitchens get wet and are sometimes next to pools. To avoid accidents, go with a non-slip material like concrete, brick, or rubber. Avoid materials like ceramic and porcelain, as they are known to be quite slippery. Wood and composite flooring can be slippery if untreated, so make sure to stain or finish these materials.

Yes, concrete driveways benefit from a driveway sealant. However, applying the wrong sealant to your concrete driveway can actually make it a safety hazard by turning the surface slippery if wet, so avoid epoxy or polyurethane sealers and go for an acrylic or a penetrating concrete sealer instead.

Epoxy and polyurethane sealers can last five to 10 years, while acrylic sealers last two to three years or more depending on the use, wear of the surface, and type of sealer you choose. Areas that see heavy traffic or extreme ice and snow may require more frequent sealing. Test your concrete every two years to gauge how it responds to absorbing water or if it fully repels it for longer than 20 seconds.