Get matched with top roof ice and snow removal pros in Pass Christian, MS

When starting the engine, you typically leave the choke on a snowblower in the "choke" or "closed" position. After starting, let the engine run for a few minutes to warm up. Then, gradually open the choke, moving it to the "open" or "run" position, allowing more air into the engine and transitioning to a normal fuel-air mixture. The exact duration varies based on the snowblower model and ambient temperature, but as a general rule, you should open the choke once the engine has stabilized and runs smoothly, typically within a few minutes.

Most roofs can take quite a bit of weight from snow, but their ability to handle heavy snow is not unlimited. Most roofs can handle about 20 pounds per cubic foot of fresh snow. Ice, ice dams, and other factors can contribute to dangerous roof weight. Newer roofs, sloped roofs, and those that have more support can hold more snow than older roofs, flat roofs, and roofs with widely spaced beams. To figure out how much snow your roof can hold, you will need to contact a professional roofing contractor to calculate the maximum snow load for your specific roof.

The best way to remove snow from driveways is to use a two- or three-stage snow blower, which has the power to clear snow in a matter of minutes. Don’t forget to consider helpful options, such as a snow thrower, wheelbarrow plow, leaf blower, and hiring a professional snow removal company to clear off your driveway.

Heavy amounts of snow could be a problem. In many climates, lots of snow on your rooftop can lead to freeze-thaw cycle that create ice dams, which can damage rooftops. But if you’re using shingle clips, this snow poses an additional problem: As it melts and freezes, it can easily dislodge clips you’ve placed on your roof.

You can clean snow off your roof after a fresh snowfall while it’s still lightweight, but brushing off snow can also dislodge your clips. If you get a lot of snow, then roof clips become less viable.