Get matched with top affordable plumbers in Nesbit, MS

You can use other ways to seal the space where your tub and the bathroom tile meet. Using sealant tape, epoxy sealer, and spray foam can be just as effective as caulking your bathtub. When using alternatives to caulk, the one that is best for you depends on your preferences. 

Sealant tape takes less time and effort to use, which is why some homeowners prefer it. Meanwhile, epoxy sealer creates a smooth and glossy finish that can complement your bathroom. Lastly, spray foam is waterproof and can act as insulation for your tub.

Dripping misters are a sign that the nozzles or holes in the tubing have some problems. Try flushing your system thoroughly. If that doesn’t help, examine each nozzle closely and clean them thoroughly with a brush, making sure the exit points are as smooth as possible. If this still doesn’t work, you may need to take off the nozzles entirely and soak them in water with a cleaning solution for a while. This is an important step if dust, mildew, or other gunk builds up in the nozzles.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

To drain a broken toilet, place towels or plastic sheeting around the base in case of splashing or overflowing. Next, shut off the toilet’s water supply, usually via a valve on the wall behind the toilet. Begin flushing the handle to remove as much water as possible from the tank and the bowl. Don’t flush the toilet if it’s clogged, though. From there, use a large sponge to soak up any remaining water and wring it over a bucket.