Get matched with top masons in Monticello, MS

Whether you’re installing brick siding over a traditionally-framed home or you’re using genuine brick construction to build, the biggest downside of a brick house is the higher cost you’ll pay for the materials and labor. Real brick construction also means your home build will take longer, as it’s more time-consuming to construct brick walls than it is to frame out your home.

Cutting stone comes with a number of safety hazards. First and foremost, if you’re not comfortable with the equipment required to cut stone, including blades and grinders, you could easily injure yourself. The heavy machinery also poses a risk to your ears if you don’t wear proper ear protection; similarly, you need to wear eye protection to keep debris from irritating your eyes.

However, the biggest risk from cutting stone comes from the stone dust. When breathed in, stone dust can be a huge hazard to your lungs. Always wear a face mask when cutting stone to prevent inhaling stone dust, and thoroughly clean the work area when you are finished.

To avoid injury, we recommend hiring a stone-cutting professional, rather than attempting this job yourself.

The best tool for drilling into brick or mortar is a rotary hammer drill which is a large hammer drill with low rotation speed and high torque. Regular drills with a hammer function are also excellent tools for drilling into brick when the diameter of the hole is 1/2 inch or less. It might be possible to drill into brick with a standard drill if you’re only drilling a very small hole, but note that masonry work will put a lot of wear on a standard drill, and the tool may not be strong enough to get through brick.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.