Get matched with top plumbers in Macon, MS

The first step to clearing the air in a line is to locate the cause. This is usually a blockage in either the drain or the venting system. Once you clear the issue, flush the system by actually flushing the toilets repeatedly. This should allow the trapped air to escape, thus clearing the lines. Don’t be surprised if there is increased bubbling as the air makes its way through the system. 

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

• Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

• Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

• Have a professional install a water pressure booster pump in your plumbing system.

• If you experience pressure fluctuations, consider upgrading to a constant pressure system.

A sewer cleanout typically looks like a white or gray PVC pipe with a removable cap. It's often located either in your yard or basement, depending on your home's plumbing configuration. The cleanout pipe is designed to provide easy access to your sewer system for maintenance and inspections. It may be flush with the ground or slightly elevated, making it distinguishable from other pipes. When you remove the cap, you can access the sewer line directly or determine its direction, which can be helpful when you need to locate your sewer line from your house to the street.

The best way to unclog a bathtub drain is to pour a pot of boiled water down the drain, being careful not to splash yourself. However, take precautions, as boiling water can damage PVC pipes and joints. Follow up with ½ cup of baking soda and ½ cup of vinegar. Cover the drain with a small sink plunger and let it sit for 15 minutes. Pour boiling water down the drain again and replace the drain stopper.