Top-rated drywall pros.

Get matched with top drywall pros in Greenville, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Greenville, MS?

Select your specific project to find the pro for you.

Find Drywall pros in Greenville

Avatar for All N One Home Services
All N One Home Services
4.7(
7
)
Drywall - InstallDrywall - Repair

Serving Greenville, MS and surrounding areas

In business since 2024

Emergency services offered

Warranties offered

"Had a great experience with these guys! Added board and batten to the walls and picture frames molding to the dining room. They were very detailed and made sure we were on the same page the entire project. I kept adding different projects like light fixtures, patching holes on dry wall and much more. I’ll definitely be using them again, as they can do it all!"
Response time8 hrs
Response rate100%
Avatar for B&BpaintingLLC
B&BpaintingLLC
5.0(
3
)
Drywall - InstallDrywall - Install - For BusinessDrywall - Repair+1 more

Serving Greenville, MS and surrounding areas

In business since 2005

Free estimates

Credit card accepted

With over 20 years experience in the painting industry, B & B Painting Interior and Exterior Commercial is your industry expert in Leflore County. We pride ourselves on our extreme professionalism and attention to detail. Our customer satisfaction guarantee will assure you we will not leave your property until you are completely satisfied with our work. As a family owned and operated business you can trust that we will treat your home as we would treat our own. Give us a call today we look forward to working with you!

Response time5 hrs
Response rate100%
Recommended by100%of homeowners
...
Showing 1-10 of 58
Drywall questions, answered by experts

New plaster must be fully dry and cured before painting. The drying time for plaster ranges from 1 to 4 hours, but the curing process can take more than five days, depending on various factors, including humidity levels, temperature, the amount of plaster used, and airflow in the area. You should always apply primer before painting plaster.

Yes, you can hammer a nail into a wall stud. But before you do, it’s important to confirm that you’re actually nailing into a stud—and not wiring, pipes, or ductwork. To check, find a few more studs in the wall, then measure to make sure they’re either 16 or 24 inches apart.

Water-damaged drywall should almost always be replaced. Not only does it look bad, it’s a breeding ground for toxic mold. Even if you think the area is dry and there’s no active leak, the only way to be sure is to cut out the damaged area and see for yourself.

The average cost to apply a skip-trowel drywall texture to walls is $1.25 to $2.00 per square foot. Ceilings cost slightly more because of the increased difficulty of working overhead. Additional cost factors include any drywall repairs and removal of existing textures or wallpaper.

Yes, a one-story house can have a load-bearing wall. The load-bearing walls in a single-story home are usually the exterior walls. If the house has a basement with exposed walls, the arrangement of the beams can help indicate what walls are load-bearing.

The Greenville, MS homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.