Top-rated door pros.

Best door pros near Ecru, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your door service project in Ecru, MS?

Select your specific project to find the pro for you.

Top-Rated Door pros in Ecru - Updated Nov 2026

Avatar for Fox Remodeling
Fox Remodeling
4.6(
17
)
Doors (Exterior) - Install or Replace

Serving Ecru, MS and surrounding areas

Approved

In business since 2019

Free estimates

Warranties offered

"Fox Remodeling was very efficient and professional. We absolutely love the results. William Fox was great to work with, very communicative and made sure we were getting what we wanted. Will be using Fox Remodeling for future needs. Highly recommend."
Tile floor
Ceramic Tile Project
Tile floor
Tile floor
Tile floor

+12

Response time1 day
Recommended by86%of homeowners
Avatar for JC Handyman
JC Handyman
4.9(
9
)
Doors (Exterior) - Install or Replace

Serving Ecru, MS and surrounding areas

Approved

In business since 2003

Free estimates

Credit card accepted

"Meticulous in his work and reasonably priced. He's talented in a lot of different things, and has great ideas and suggestions. He'll let you know if a project is out of his scope of ability and point you in the right direction, but anything he has said he is able to do, I've been happy with. He operates with integrity and honesty, you really don't come across that very often these days."
Response time1 day
Recommended by100%of homeowners
...
Showing 1-10 of 104
Doors FAQs, answered by experts

You should generally cut between 1/8-inch and 1 inch when planing a door. If you cut off more than that, you risk damaging the door. Planing too much from the bottom of your door can cause noticeable gaps, so it’s always better to start with as thin of a section as possible and work in thin layers until your door no longer sticks.

You can convert a pre-hung door into a Dutch door, but it’s more of a pain. Pre-hung doors are already set in the frame with the hinges and everything aligned, so once you cut the slab in half, you’ll likely need to adjust the hinge placement and maybe even mess with the frame itself. It’s doable, but expect some trial and error because it’s not a straight-swap situation.

Depending on the type of French doors you choose, they may be more expensive than sliding doors. Generally speaking, a single in-swing or out-swing French door will cost less than a sliding door, as it contains fewer materials and is easier to install. However, sliding doors usually have a slightly lower price tag, especially when compared to the standard double in-swing or double out-swing French doors.

Permits are required when carrying out any structural work, so in most cases, you will need a building permit to cut through a concrete block wall to install a door. If you have specific questions about your project or need to obtain a permit, contact your municipal building department or ask your contractor for advice.

Standard door sizes aren’t one-size-fits-all, but there are common go-to dimensions. For exterior doors—like your front door—36 inches wide by 80 inches tall is typical, though you’ll see 30- or 32-inch widths too, especially in older homes. Interior doors vary more. Bedrooms and bathrooms often use 30- to 32-inch widths, and closet doors can be anything from slim singles to wide bi-folds. Height is usually 80 inches across the board; however, always measure your actual opening. “Standard” only works if it matches what’s already in place.

The Ecru, MS homeowners’ guide to door services

From average costs to expert advice, get all the answers you need to get your job done.