Get matched with top epoxy flooring pros in Crawford, MS

How do I epoxy a garage floor?

To epoxy a garage floor, you need to measure the area of the floor, remove all items from the garage, thoroughly clean the floor, and then follow the manufacturer’s instructions to mix and apply the epoxy. Learning how to epoxy a garage floor can save you between $4 and $7 per square foot on labor.

If your garage floor is heavily soiled or stained, then it’s a good idea to powerwash it with a concrete cleaner before sealing. This process will remove dirt and debris to help the new sealer bond to the concrete properly, and it will also improve the look of your sealed garage floor. After power washing your floor, make sure you let the concrete dry completely before applying sealant, usually for 24 to 48 hours.

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.

While you shouldn’t use thinset mortar on its own as a floor leveler, it can work alongside other products to help level floors. For instance, you could start with a self-leveling compound, let that dry, then apply backer board with thinset mortar to help fully even out the floors ahead of laying tile.