Get matched with top toilet pros in Blue Mountain, MS

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

If your toilet won’t stop running, you might have a bad fill valve. This may be the case if the valve has calcium or debris buildup, is cracked, or shows visible signs of wear and tear. A bad fill valve may also be the culprit if you’ve already checked the flapper and chain and adjusted the fill height to no avail.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

While you don’t have to run out and immediately buy a new toilet at the first sign of a clog, if the toilet keeps clogging because it’s a low-flow or poorly designed model, a new toilet may be the way to go. If your toilet keeps clogging, you can try using less toilet paper, adjusting the fill valve, checking the toilet vent pipe on the roof, and using a toilet auger to make sure nothing is stuck in the pipe or trap.