Get matched with top toilet pros in Hickory Flat, MS

While you don’t have to run out and immediately buy a new toilet at the first sign of a clog, if the toilet keeps clogging because it’s a low-flow or poorly designed model, a new toilet may be the way to go. If your toilet keeps clogging, you can try using less toilet paper, adjusting the fill valve, checking the toilet vent pipe on the roof, and using a toilet auger to make sure nothing is stuck in the pipe or trap.

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

You definitely can over-tighten toilet tank bolts. Unlike some other materials, porcelain can’t bend or flex, so when you over-tighten a screw into it, it could break against the added pressure. Only tighten them as much as needed to keep them in place and firm; any more and you could risk breaking the porcelain.

To drain a broken toilet, place towels or plastic sheeting around the base in case of splashing or overflowing. Next, shut off the toilet’s water supply, usually via a valve on the wall behind the toilet. Begin flushing the handle to remove as much water as possible from the tank and the bowl. Don’t flush the toilet if it’s clogged, though. From there, use a large sponge to soak up any remaining water and wring it over a bucket.