Get matched with top electricians in Pilot Knob, MO

Using a wire stripper/cutter, strip about 1/2 inch to 1 inch of sheathing from electric wires, depending on the application. A self-adjusting wire stripper/cutter works best, but a standard wire stripper/cutter with holes for different gauges of wire works as well to cut and strip away the sheath without damaging the copper wire inside.

While washers and dryers do not require a GFCI (ground fault circuit interrupter) outlet to function properly, electrical codes often mandate their use for safety. The National Electrical Code (NEC) requires GFCI protection for all outlets within six feet of a water source. This means a washer and dryer must be plugged into a GFCI outlet if they are installed in locations like a laundry room, utility room, garage, or basement. In other areas without a nearby water source, there is no specific requirement, but using a GFCI outlet is still recommended for extra peace of mind. It is always best to consult your local codes and regulations to ensure compliance and safety.

Yes, one wire is always hot on the 3-way switch, meaning it carries the electricity from the power source to the switch. If you have a 3-wire cable in your home, you have two hot wires, or line wires, coming from the power source. Typically, you’d connect the hot black wire from the power source to the traveler wire and the hot red wire from the power source to the first 3-way switch. For the second 3-way switch, you’d then connect the hot black traveler wire to the switch.

Yes, many professionals offer surge protection to safeguard equipment from power fluctuations.