Top-rated contractors.

Best contractors near Holcomb, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Holcomb, MO?

Select your specific project to find the pro for you.

Top-Rated Contractors in Holcomb - Updated Nov 2026

Shane Hampton
New to Angi
Major Home Repairs (General Contractor)

Serving Holcomb, MO and surrounding areas

Approved

In business since 2013

Free estimates

Locally owned and operated company that values honesty and integrity and treats your home as if it were our own. We offer a variety of quality home improvement services. You will find us to be competitively priced with close attention to the details of each and every project that we are involved with. We look forward to building lasting relationships and guarantee your satisfaction!

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Holcomb, MO and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Siding Repair Systems
Siding Repair Systems
4.5(
128
)
Major Home Repairs (General Contractor)

Serving Holcomb, MO and surrounding areas

In business since 2009

Free estimates

Credit card accepted

"The estimate and the people doing it was good. They knew what they were talking about and took their time. They said the work would start early February before they can start, which is fine its no rush. But we would appreciate if they could just give us a date. My wife has chased them down and they haven't gotten back to her. Just keep us in the loop, we shouldn't have to chase them down. We understand if the weather delayed or a set back. Its not hard to make a call or send an email."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+6

Recommended by89%of homeowners
All Pro Contracting
5.0(
3
)
Major Home Repairs (General Contractor)

Serving Holcomb, MO and surrounding areas

In business since 1988

Free estimates

Emergency services offered

"Mike was a pleasure to work with and was very responsive in the time leading up to the job and while the work was being completed. I was kept up to date and his team came in at budget and on time. We were very pleased with our new siding as well as the stone veneer that was added to our lake house."
Recommended by100%of homeowners
Showing 1-10 of 32
Unfinished Carpentry FAQs, answered by experts

There are both temporary and permanent ways to enclose a carport. If you’re looking to enclose your carport for the winter, a canvas enclosure could do the trick. It won’t be as protective as a permanent structure, but it can offer some protection from elements like snow, rain, and wind. For a permanent enclosure, you can add extra walls, add a new vertical roof, or a lean-to addition on one side of the structure.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Yes, professionals can install new frames, trim, and threshold adjustments for a complete finish.

A cross brace for a fence gate should stretch from the top corner of the gate’s hinge side to the bottom corner of its latch side at a 45-degree angle to the bottom of the gate. This positioning distributes the bulk of the gate’s weight to the base of the post, taking pressure off the top hinge.

Framing with metal studs can be significantly faster than using wooden studs, provided you have some experience working with the material. While you can use virtually instant pneumatic nailers with wood, metal requires installing screws. However, because metal is lighter, straighter, usually comes cut-to-length, and doesn't require sorting for the best pieces, you can save significant time using metal instead of wood.

The Holcomb, MO homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.