Top-rated electricians.

Get matched with top electricians in Crocker, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Crocker, MO?

Select your specific project to find the pro for you.

TRUSTED BY CROCKER, MO HOMEOWNERS

  • Average homeowner rating star icon4.5
    Average homeowner rating
  • Verified reviews icon49
    Verified electrical services reviews

Find Electricians in Crocker

Steve Stockmsn
New to Angi
Ceiling Fan - InstallCeiling Fan - RepairElectric Vehicle Charging Station Installation - Materials Not Provided+12 more

Serving Crocker, MO and surrounding areas

Approved

Free estimates

Emergency services offered

Small jobs welcome

I am a retired journeyman electrician with an apprentice available for attic work and bigger jobs. I have experience installing charging stations, upgrading distribution panels, remodels, basement finishes, and have overseen Large lighting layouts and LED upgrades.

...
Showing 1-10 of 88
Electrical questions, answered by experts

Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.

There are several indicators that a single-pole switch is bad: the switch is warm or hot to the touch, sparks are sometimes present when turning the switch on or off, you hear a buzzing sound or other weird noise coming from the switch, the connected light flickers when you turn on the switch, and the light doesn't turn on at all with the switch. If you notice any of these, replace the switch or call a pro straight away.

Yes, it’s safe to strip a wire if you follow the proper safety precautions. First and foremost, you must always disconnect the power and never try stripping a live wire. Using wire strippers is another safety precaution, but don’t forget to keep your fingers away from the blade. It’s also critical you only remove the insulation and not accidentally cut into the conductor, which is unlikely as long as you’re using the right-sized wire stripper.

Each meter should have a serial number printed or engraved on the face of the meter. Make sure the serial number of the meter you are reading matches your account with the power company. If you live in an apartment complex, the meters are likely located all together. Yours should be labeled according to your apartment unit.

Unfortunately, a partial power outage without a tripped breaker often means you have a major wiring issue or that the breaker itself is going bad. When the power is out in one room but the breaker is not tripped, you need to call an electrician as soon as possible to identify the cause of the problem and repair it.

The Crocker, MO homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.