Top-rated above ground pool installation pros.

Best above ground pool installation pros near Spring Grove, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Spring Grove, MN?

Select your specific project to find the pro for you.

Top-Rated Above ground pool installation pros in Spring Grove - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Spring Grove, MN and surrounding areas

In business since 1971

Credit card accepted

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools FAQs, answered by experts

It is a good idea to brush a pool before shocking. Brushing the sides and floor loosen up anything that is growing on the surface, such as algae. It is then easier for the pool shock to kill the contaminants because more of it will come in contact with the chemicals.

Technically, you can fill in a pool yourself—with the caveat that filling in a pool requires the ability to drain the pool properly and move a substantial amount of dirt, which aren’t beginner DIY skills. If you want to fill in a pool, you’re better off hiring a local pool removal professional.

You can check if your pool is bonded by looking for a copper wire that connects to the motor and pumps and then extends into the ground. However, if you’re unfamiliar with electrical wiring, contacting a pool electrician to inspect the motor and pumps is safest. An electrician can check the system and determine if it is up to code and meets all swimming pool bonding requirements.

While you can save some money by digging your own pool, you may end up paying more in construction equipment rental fees in the long run. You could, however, focus your DIY energies on lowering the cost of leveling your lawn for your pool or filling in surrounding landscaping after construction.

The best way to dissolve algae is to use pool shock. The shock increases the free chlorine levels in your pool, which in turn kills bacteria, microorganisms, and algae. You can opt for granulated shock that you mix with water or a premixed liquid shock.

Keep in mind that using pool shock is just one of the steps you need to take to get rid of algae from your pool. Unless you also brush, vacuum, and clean the filter, your algae problem may return.

The Spring Grove, MN homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.