Get matched with top above ground pool installation pros in Mabel, MN

Generally speaking, you should expect to wait 24 to 48 hours after filling a pool before you use it. However, the actual timeline depends on a few factors. Most importantly, you need to shock the water with chlorine or an alternative to swimming pool chlorine and let the concentration come down to a safe level before using the pool. Additionally, most water sources will be cold, and it can take days before the sun or your pool heater warms your water to a comfortable temperature. Alternatively, getting water professionally delivered could have you swimming in just a few hours.

If your pool takes longer than one or two days to fill, you might be dealing with low water pressure. Using a water pressure gauge on your outdoor tap, you can check your water pressure. A reading of 40 psi or below is considered low. A leak, a nearby water shutoff, or several other reasons could cause this. 

If the water pressure isn’t a problem, you could have a low flow rate from clogs, corroded pipes, or other plumbing issues. It’s best to call in a local plumber to get to the root of the issue.

How often you should add water to your pool depends on how quickly the water evaporates. Keep an eye on your skimmer box, if you have one. Top up the water in your pool if you notice the water levels are lower than the bottom third of your skimmer. This helps prevent damage to your pump. 

Replace all the water in your pool every five to seven years, depending on how often you use your pool, the weather, and whether or not you close your pool for the winter.

You can spend less time and money on plunge pool maintenance since they are smaller than standard pools. These pools are easier to clean and maintain yourself than a swimming pool. But like any pool, you’ll need to clean the pool walls and floor, balance the chemicals, check the electrical equipment, make necessary repairs, etc.