Top-rated ceiling fan pros.

Get matched with top ceiling fan pros in Dent, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your ceiling fan service project in Dent, MN?

Select your specific project to find the pro for you.

Find Ceiling fan pros in Dent

Avatar for Garden Structures & More
Garden Structures & More
4.6(
73
)
Ceiling Fan - InstallCeiling Fan - Repair

Serving Dent, MN and surrounding areas

In business since 1998

Free estimates

Emergency services offered

"Let me say, there are fencing companies, and then, there is Garden Structures & More.  You really cannot even begin to compare the two.  Hal is a top-notch craftsman from start to finish.  This was not a typical fencing job, where sections are brought in, posts are set into the ground and the sections attached to the posts.  This was an entirely different experience.  The fence was built on site, board by board.  The vertical boards in the lattice actually go all the way down to the bottom of the fence. Of course, doing it that way requires a bit of a mathematical genius, when you are dealing with different width boards in between the lattice boards-- especially when you get into the corners where sections need to be a different width from the standard size. I also realized how much care was taken in dealing with the slight level differences in my yard. Hal was careful to make adjustments when possible, so that the top line of the fence remained level, even though the ground did not.  It is sturdier than any fence I've ever seen, and the attention to detail is wonderful.  Every side of each board is routered to give it a softer edge.  The posts don't need a cap.  The tops are routered the same as the rest of the fence, and they look simple and clean, a lovely complement to the clean lines of the fence as a whole.  The double gate with arbor is really beautiful.  I'm not a fan of black hardware, and Hal supplied some beautiful stainless that looks so much nicer.  Hal started right on schedule, and ended exactly when he said he would.  And, he is very thoughtful.  Not only did he build me a beautiful fence, but he put up a bird feeder that I hadn't gotten around to doing myself, and even brought my garbage cans into the garage on garbage day!  In the days since the fence was completed, I have received many compliments on the fence and arbors from people walking by.  And, they have also commented on what a nice crew installed my fence-- that it seemed like a great group of guys.  I would use Garden Structures and More again, in a heartbeat.  It was a great experience!
  
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+10

Recommended by95%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Ceiling Fan - InstallCeiling Fan - Repair

Serving Dent, MN and surrounding areas

In business since 1971

Credit card accepted

"The furnace took 4 days to get approved( not counting a Sunday) the others were quick but the water heater had to be ordered so without hot water for a week. One ceiling fan was easy but within a year their policy changed and They would not install the one I purchased and had to get a new one approved and then ordered online and took several weeks to get straightened out. Not sure who was at fault, AHS, installer or scheduling with renter. Fee is usually $75 per visit"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Ceiling Fans questions, answered by experts

If you’re removing a ceiling fan without visible screws, start by locating the fan canopy—a round cover placed above the fan blades and motor. There should be a thin ring that can be turned counterclockwise to remove the canopy and reveal the screws. After unscrewing the fan, you can disconnect the wires and remove the entire fan from the mounting hardware. For safety, make sure the fan switch is turned off before you remove the canopy. It may be easier to remove the fan blades first, too.

The most efficient ceiling fan height is 8 to 9 feet from the floor to the fan blades. For ceilings higher than 9 feet, a downrod can be used to lower the fan to the optimal height. This positioning ensures adequate air circulation and maximizes the cooling effect. Remember, fans should be installed at least 7 feet above the floor for safety.

The direction your ceiling fan spins helps create comfortable airflow in your home and can also help cut down on energy costs. 

During summer, your ceiling fan should spin counterclockwise. This will push cooler air downward in a column and help lower your room’s air temperature. In the winter, set your ceiling fan to spin clockwise and at the lowest speed setting. This will pull cool air upwards, displacing the warm air that pools towards the top of your ceiling and bringing it down towards the floor.

The number of blades for your fan poses both advantages and disadvantages. Typically, the more blades on a fan, the better the air distribution and cooling effect, but this also means that your fan will have more wear on its motor. For small rooms, three-blade fans should work fine. For larger areas like living rooms, four or five-blade fans might be the better option. 

Essential tools for ceiling fan installation include a ladder, screwdriver, pliers, wire strippers, and a circuit tester. If the ceiling is angled or features unique configurations, ensure the availability of a compatible mounting bracket.

The Dent, MN homeowners’ guide to ceiling fan services

From average costs to expert advice, get all the answers you need to get your job done.