Serving North Dakota and Western Minnesota with offices in Grand Forks, Valley City, and Jamestown\nFresh, clean, tasty water is our business! We strive to keep your home's plumbing new by removing the minerals that deposit in pipes and on fixtures. These same minerals prevent your soap from doing its job - cleaning your family and all that you own.\nIn addition, we can filter chlorine, iron, manganese, nitrates, arsenic, cysts, fluoride, and even radium from your water. We specialize in fixing your personal water issues.
"We pay yearly but we have this is included with our rental property. They are pretty good on most things. We had a hot water heater replaced and they did an excellent job on that. They are very quick on their response. They dont come out here. It is all done on the internet. I just like the idea that one time service charge is so much better than trying to hiring someone to come in. It is more about convenience. It pays for itself."
Installing a water heater without a permit can result in high fines—as much as hundreds of dollars per day, in some areas. It can also void your homeowners' insurance and cause problems when selling your home because it violates local building codes and safety regulations.
Water heater installation code requirements are in place to keep your family and home safe. Water heaters that are installed wrong can simply not work. However, that's an, if you're lucky, type of situation. More commonly, incorrectly installed water heaters pose a real threat from carbon monoxide poisoning, gas leaks, water leaks, and even explosions.
Most standard residential water heaters, which are typically around 40 gallons and use 240 volts and between 3,500 and 5,500 watts, require a 30-amp, two-pole circuit breaker. For smaller, point-of-use water heaters using 120 volts and between 1,500 and 3,000 watts, a 30-amp breaker is also often adequate. However, some models may have different needs; units that use more watts than average may require a 40-amp breaker, while smaller units might only need a 20-amp breaker. Newer, tankless, or more energy-efficient models can also require a higher amperage. Having the correct breaker size is crucial for safe and efficient operation, so it's best to consult a licensed electrician to determine the specific needs of your water heater.
Most hot water heater manufacturers recommend replacing the anode rod about once every three to five years. Anode rods sacrifice themselves by collecting iron, limestone, and other minerals that would otherwise corrode your hot water heater tank. This abuse wears them out long before your water heater does. Check the rod when you remove it and replace it if more than 50% of the metal has been consumed. Check the rod more frequently if you have hard water or use a water softener.
Typically, only a high-efficiency water heater with an inducer fan can be vented outside the house. Otherwise, your water heater needs to be installed on the inside and vented through the roof. However, certain areas may allow a standard-efficiency water heater to be vented outside. Check your local building codes to be sure.
The Badger, MN homeowners’ guide to water heater services
From average costs to expert advice, get all the answers you need to get your job done.
Looking to replace or upgrade your water heater? Use this water heater replacement cost guide to see what the work will cost and what factors affect your total.
A water heater flush costs $160 on average but can vary based on the unit size, type, labor, location, and more. Keep reading to learn how much you could pay.
Wondering how much a water heater expansion tank costs? Use this cost guide to get an accurate estimate and learn how to choose the right one for your home.
Who can install a water heater for you? Look to hire a water heater installation pro or a licensed plumber for this job because of the challenges involved.
The average lifespan of water heaters is 6 to 15 years for conventional models and up to 20 for tankless ones, but it can be less if they are not properly maintained.
