Get matched with top toilet pros in Levering, MI

Yes, you can clean a toilet tank with white vinegar. Before you do, shut off the water supply to the toilet. Then, flush it to empty the tank. Next, combine one part vinegar with one part water in a spray bottle and spray the mixture inside the tank. Let it sit for 10 minutes, then rinse away the vinegar by pouring clean water into the tank. Make sure the tank is empty, then dip a scrub brush in vinegar and clean the tank’s inside walls. Turn the water back on and flush again to rinse away the vinegar.

If you’ve accessed the bolts and nuts that hold your toilet seat in place and can’t unscrew them, it’s possible that they were overtightened or that the material corroded over time, making it impossible to unscrew. If that’s the case, you can either call in a plumber for help, or you can DIY a solution if you’re careful. Lay down masking tape around the mounting bracket and then use the tape as a surface to lay a hack saw blade. Move slowly to cut through the bracket and bolt, being careful not to damage the porcelain in the process.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

To drain a broken toilet, place towels or plastic sheeting around the base in case of splashing or overflowing. Next, shut off the toilet’s water supply, usually via a valve on the wall behind the toilet. Begin flushing the handle to remove as much water as possible from the tank and the bowl. Don’t flush the toilet if it’s clogged, though. From there, use a large sponge to soak up any remaining water and wring it over a bucket.