Get matched with top stone countertop pros in Rangeley, ME

No, you should not put a hot pan or pot directly on a quartz countertop. While quartz is generally heat-resistant, the resin binders used in its manufacturing are sensitive to extreme heat from items exceeding 150 degrees Fahrenheit. This can damage the resin, leading to discoloration, burns, or even cracking. To prevent permanent damage, always use trivets or hot pads for hot cookware.

The best tool for cutting countertops depends on the type of countertop material. For some softer materials, like laminate (Formica) and butcher block, you can use a hand saw, but most experts recommend power saws like circular saws, since these make the job go faster and easier and give more even results. However, power saws and circular saws are dangerous if used incorrectly, and they can be so powerful that they damage or chip laminate, stone, and other types of countertops. For this reason, you should take safety precautions and use best practices to prevent damage.

Quartzite is more expensive than granite, largely because of its rarity. Granite is naturally more common. A granite slab generally costs $40 to $60 per square foot (excluding super-rare types), while quartzite slabs cost anywhere from $50 to $150 per square foot. 

With both materials, it’s usually more affordable to purchase stones that are readily available in your location. You may need to import other stones, which come at a higher cost.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.