Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Baileyville, ME

Enter your ZIP and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Baileyville, ME?

Select your specific project to find the pro for you.

Find Bathtub restoration pros in Baileyville

Avatar for American Tubs....

American Tubs....

2.33(
3
)

American Tubs....

2.33(
3
)
Customers say: Terrific value
13 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Costs vary by materials used, surface size, and complexity. Refacing can be cost-effective compared to full replacements, with an average range between $300 and $1,200.

The difference between resurfacing and refinishing is that refinishing only works on solid surfaces that are in good condition, whereas resurfacing will restore a cracked or worn surface to its original, blemish-free state. Refinishing will leave you with a smooth and glossy surface you can’t get from resurfacing alone. If that’s the look you’re going for, contact a local concrete finishing contractor to achieve it.

Refinishing a bathtub takes about two to four hours, but let the surface set for another 24 to 48 hours before using it again. Once it's set, your tub should last for 10 years or more. Ventilating the bathroom during this time is key for safety. In comparison, it takes about four hours to install a new bathtub.

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.

The Baileyville, ME homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles