Get matched with top bathtub restoration pros in Cherryfield, ME

Surprisingly, cleaning an air bath is almost as easy as relaxing in one. Most air baths have a self-cleaning or drying cycle to remove moisture from the inner tubing. This prevents mold and keeps the tub ready for your next soaking session. For deeper cleaning, use mild soap and a soft cloth to wipe the surfaces and periodically clean the air jets as the manufacturer recommends.

While tubs are fairly sturdy, you may notice cracks or holes. This kind of damage can happen from someone accidentally dropping something heavy into the tub. You might also see damage if you drop something heavy into the tub over and over again (like your extra large bottle of body wash). While you might only notice a small dent at first, this can later turn into a crack or a hole.

Also, certain cleaners that are harmful to your tub can cause damage. And if you have a fiberglass tub, you might see cracks if it was not installed properly with the right support.

No. You should let the caulk completely dry before you expose it to moisture. It’s safest to wait at least a full day before showering where you’ve recently caulked. Showering before caulk is fully dry can lead to a poor seal, meaning water can seep into cracks and cause damage and mold growth. 

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.