Get matched with top lighting pros in Rosedale, MD

It’s fair to be concerned about handling pool lights or wiring in a pool filled with water. But fortunately, pool lights and swimming pools are designed to make it easy and safe to replace the lights without needing to drain the water. Instead, you can turn off the electricity to the pool as a safety precaution, unscrew the pool fixture, pull it up and out to the side of the pool, then change the bulb.

While wet-rated and damp-rated lighting is designed to handle contact with moisture, there’s a difference between the two. Wet-rated lighting is safety-rated to be placed in areas with direct exposure to water, including your shower. Fixtures classed as wet-rated are made with waterproof seals to protect the filament and other electrical components from water and moisture. 

Damp-rated fixtures can be used in places with some moisture contact, but not direct exposure. They don’t have the same waterproof seals used in wet-rated fixtures. Damp-rated lighting can be used on your bathroom ceiling or along a wall outside of your shower.

There are tons of different types of landscape lighting available, including the choice between solar and wired, incandescent and LED, and a variety of colors. Specific types of lighting include:

• Pathway lights: $50–$150 per fixture

• String lights: $50–$150

• Low-voltage lights: $90–$150 per fixture

• Porch lights: $65–$250 per fixture

• Floodlights: $75–$250 per fixture

• Downlights: $100–$400 per fixture

• Uplights: $100–$400 per fixture

• Security lights: $ 350–$500 per fixture

• Lamp posts: $400–$1,100 per lamp post

If half of a string of Christmas lights is out, it is likely because of a single burned-out, loose, or broken bulb within that section. Long strands of lights often contain more than one circuit, so when one bulb fails, it can cause the entire circuit (or half the strand) to go dark. To fix this, inspect the unlit section and test each bulb to ensure it is tight and functioning properly. Replacing the faulty bulb or repairing a damaged shunt will typically solve the problem.