Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Parkton, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Parkton, MD?

Select your specific project to find the pro for you.

TRUSTED BY PARKTON, MD HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon111
    Verified drywall insulation services reviews

Find Drywall insulation pros in Parkton

Avatar for Koala Insulation of The Greater Baltimore Area
Koala Insulation of The Greater Baltimore Area
4.8(
13
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Parkton, MD and surrounding areas

Approved

In business since 2023

Free estimates

Warranties offered

"We had insulation installed a week earlier by Koala. During the insulation, Jasper (insulator) suggested another area that we might consider installing blown-in insulation. We agreed and the second job was performed on Friday, the 24th. Jasper and Richard were on time, the insulation project was well done and they left the area very clean. Would use them again."
Insulation Projects
Spray Foam Insulation
Insulation Projects
Blow-in Rig
Truck

+9

Response time8 hrs
1 neighbors recently requested a quote
Recommended by83%of homeowners
Avatar for Mister Insulation LLC
Mister Insulation LLC
5.0(
8
)
Blown-In Insulation - Install or Upgrade

Serving Parkton, MD and surrounding areas

Approved

Super Service Award Winner

In business since 2000

Free estimates

Emergency services offered

"We called Mister Insulation and Jeff came out in a day or so. We explained that we purchased new windows and doors and had insulation blowen into the walls but the house was still not warm. He took pictures in the attic and used a thermal camera to show where we were losing heat also we had mold. He removed the mold and replaced the insulation . He and his crew were very professional. We would recommend them ."
Energy Evaluation
EnergyStar Seal
Building Code
NASA Tech!
Solar Venitilation

+1

Response time8 hrs
Response rate94%
5 neighbors recently requested a quote
Avatar for Atlas Home Energy Solutions
Atlas Home Energy Solutions
4.1(
34
)
Blown-In Insulation - Install or Upgrade

Serving Parkton, MD and surrounding areas

Approved

In business since 2009

Free estimates

Credit card accepted

"I hired Atlas Home Energy Solutions to remove old insulation and replace it with the foam technique. However, I ran into numerous unexpected problems due to a slow leak from old pipes. It took awhile to sort out. Atlas Home Energy Solutions gave me lots of expert advice. They were willing to come out and review the situation. They were also willing to reschedule and wait until another contractor dealt with the water issue and its ensuing problems. They helped me make some difficult decisions before they could insulate the crawl space. When it was ready for them to come and insulate the area they bumped their schedule forward to get it done. This company did sterling work. Their expertise and professionalism were outstanding. They really know what they are doing and guided me through a more protracted process than originally envisioned. I would highly recommend them to anyone."
Visual Inspection of all Areas of your Home
Attic Insulation and Air Sealing
Infrared Camera Inspection
Attic Spray Foam
Blower Door Whole House Air Leakage Test

+11

Response time1 day
Recommended by87%of homeowners
Avatar for ROI Construction LLC
ROI Construction LLC
4.1(
18
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Parkton, MD and surrounding areas

Approved

In business since 1974

Free estimates

Warranties offered

"We had a great experience with ROI Construction sales representative David Burke. David was very knowledgeable about ROI's porducts and services. We look forward to getting our attic insulation project completed and will provide a more thorough review at that time. Thanks, Tim"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+19

47 neighbors recently requested a quote
Recommended by90%of homeowners
Cameron Home Insulation
4.6(
40
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Parkton, MD and surrounding areas

In business since 1907

Free estimates

Credit card accepted

"Debbie, the AC&R salesperson, was very knowledgeable and confident. They were the 2nd quote I got for work and came in even lower than I expected (which gave me pause as a low bid is a red flag). But true to her word, they did the work professionally (mostly...see below) and promptly. While I had another company do the energy audit for the Pepco rebate, AC&R took over the work, did the blown fiberglass one day and the spray foam the next.



For the blown fiberglass in the attics above our additions, they added spray foam (from a can) around any gaps per the contract and foam board baffles at the soffits. The installer noted that all our soffits were blocked and the batting insulation was too wide for the rafter channels, so he leveled it out as best he could to ensure an even coating of blown insulation. At the end, he sealed up the gaps between the attic and our to-be-finished upstairs (cape cod style, so all one room).



For the spray foam insulation, the team came in the next day, and I had to be out of the house due to fumes. I did come back around noon as they expected to be done well before then. They didn't know I came in and I went to the back of the house to watch TV on my work break. The one annoyance was during their cleanup, one of the installers came down into our kitchen and then saw me. He said he was looking for a vacuum cleaner to clean the stairs. I told him don't worry about the carpet as it was getting pulled up, but this was the one piece of unprofessionalism I noted above. Contractors should NEVER use the homeowner's property; they should bring their own tools, including vacuums!



While the spray foam can get very messy, they kept the splatter mostly contained to inside the crawlspace, not the finished flooring. However, I was surprised that they didn't tape off the outlet covers or light switched. since the particles are so small, we're going to have to replace the switches/receptacles at our cost. Also, there was a storm door screen that wasn't covered and now needs cleaned. Basically, I think they should have taken more care in covering the very few items we left upstairs and the outlets/switches.



They didn't spray around the window frames (large gaps where window weights used to be) because the open cell foam would expand too much. If I wasn't there, I think they would have just left, but it was clear in our contract discussions they needed to insulate those spaces too. They used a few cans of "Good Stuff" equivalent, but didn't fill in the gaps entirely. It did the job well enough, but it's a ding against them as I expected more preparation.



Lastly, I thought that AC&R would walk me through all the scheduling and final "test out" (for the Pepco rebate), but I had to contact them and schedule with someone different each time. They were always prompt, but I expect the experts to know to do this for/with me rather than expect me to know the process. I go through it once in a lifetime while they do it weekly.



While the end of the review sounds more negative than positive, I would definitely recommend AC&R out to others as they're priced right, they have been in business for over a century, and like any contractor, you just need to follow up to be sure everything is done to your satisfaction.
"
Recommended by100%of homeowners
Avatar for Home Energy Loss Professionals (HELP)
Home Energy Loss Professionals (HELP)
4.4(
73
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Parkton, MD and surrounding areas

In business since 2004

Free estimates

Emergency services offered

"Very professional, on time, great communication, thorough examination of my home. This is an absolute requirement for any home owner. The equipment they provide (LED lights, low flow equipment, pipe insulation) is well worth the fee to have the audit conducted."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Recommended by87%of homeowners
Avatar for Insulation Geniuses
Insulation Geniuses
4.6(
9
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Parkton, MD and surrounding areas

In business since 2016

Free estimates

Emergency services offered

Same quality and company, NEW NAME!!!! Yep we've upgraded our branding to better reflect out company goals. As always, quality products are essential for success, but without certified and trained technicians installing everything to the exact specifications for greatest success, your home wouldn't get the best results. That's why we do things right - every time. Our excellent products come with extended/lifetime warranties INCLUDED - there will never be an upcharge for a warranty. The adage "you get what you pay for" is 100% true for Insulation Geniuses. We'd rather explain the investment up front rather than trying to explain quality for the next 20 years...

Another Happy Homeowner!
Aeroshield NASA Grade Insulation
Energy Star Attic Seal Process
Gable Attic Fan - SOLAR POWERED!  Runs for FREE and 25 Year Warranty!
AeroShield Installed over Blown-In gives you the right protection forever with it's LIFETIME Warranty!

+37

Recommended by88%of homeowners
...
Showing 1-10 of 55
Drywall Insulation questions, answered by experts

A common cause of separation between a wall and the ceiling is truss lift—this can happen to the ceiling of rooms directly under the attic when the seasons change and wood building materials dry out, shrink, and shift. Roof trusses often dry out at different speeds, and if the bottom pieces dry out faster than the top pieces, they can shrink and pull the attached drywall away from ceilings and walls, causing cracks. Fortunately, truss lift is only a cosmetic problem, not a structural problem, and you can fix it by separating the ceiling drywall from the roof trusses, and patching the cracks.

Regularly in areas prone to moisture or high traffic to catch issues early.

Plaster can be a difficult DIY to master, especially if you plan to plaster an entire room, rather than patch a small area. Before you begin a plaster DIY project, you need to know which tools and type of plaster to use. It's also important to know how to prepare the surface and apply the plaster for a smooth finish. If that all sounds like a lot of work, you may prefer hiring a local plaster repair contractor to do the job.

Although they have similar applications, spackle and joint compound are not the same. Their primary differences lie in their composition, consistency, and ideal use cases.

Spackle is composed of gypsum and binding agents, making it thicker than joint compound. It dries quickly and is easy to sand, which makes it ideal for small wall repair projects like filling nail holes or patching minor damage.

Joint compound, also known as drywall mud, consists of limestone and gypsum. It is primarily used for large-scale projects, such as taping and finishing the seams on newly installed drywall. It tends to shrink more than spackle and can be more difficult to spread.

While both products can be used to fill small depressions and cracks, spackle cannot replace joint compound for taping and mudding new drywall. Conversely, you can often use joint compound for small patching jobs typically done with spackle.

Wall anchors are suitable for drywall and plaster walls, which are common in most homes. However, different wall materials may require specialized anchors. For concrete or masonry walls, you'd typically use concrete anchors. When dealing with other wall types, such as brick or tile, specific anchors designed for those materials may be necessary. Always consult with a hardware specialist or check the manufacturer's recommendations to ensure you select the appropriate anchors for your specific wall type.

The Parkton, MD homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.