Get matched with top pool and spa technicians in Hydes, MD

Generally, it is more cost-effective and energy-efficient to leave your hot tub on all the time rather than turning it on and off. Reheating a hot tub from a cold temperature consumes a significant amount of energy, so maintaining a constant temperature is usually more economical, especially with frequent use.

For daily or weekly use, it's recommended to keep the water at a constant, reduced temperature, such as between 80 and 95 degrees Fahrenheit, and then increase it to your desired temperature before getting in. If you know you won't be using the hot tub for an extended period, you can lower the temperature to save on energy costs. However, if you use it very infrequently, you can turn it off completely, as long as there is no risk of the water freezing.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

A compact unit designed for two to three people typically weighs approximately 500 pounds in its empty state. On the other hand, a larger hot tub meant for up to six people can weigh around 1,000 pounds when empty. Materials used also impact weight. Less expensive hot tubs are typically lighter because they are made of molded plastic or fiberglass.

Most hot tub motors can last between five and 10 years; however, hot tub motors can burn out sooner if the hot tub water is not maintained or if the motors themselves are not maintained or protected from the elements. Since hot tub motors (also referred to as spa pumps) power the jets and circulate the water, they are important for the functioning of your spa. Buying a quality motor, keeping the hot tub filter clean, and keeping the wet end of the motor wet and the dry end dry can help them last longer.