Top-rated masons.

Best masons near Sulphur, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Sulphur, LA?

Select your specific project to find the pro for you.

Top-Rated Masons in Sulphur - Updated Nov 2026

Avatar for Platinum Construction
Platinum Construction
5.0(
7
)
Brick or Stone - Tuck-pointingBrick or Stone - Tuckpointing - For BusinessBrick or Stone Siding: Install or Completely Replace+3 more

Serving Sulphur, LA and surrounding areas

In business since 2020

Free estimates

Warranties offered

"Was totally satisfied with the job they did. I had 10 of my pillars bricked and they came out great. The team was on time and cleaned up as they went no mess left behind. That was a key point l noticed. Sometime contractors are bad about clean up, but this crew was outstanding. Would highly recommend Platinum Construction for any of your masonry/brick layer needs."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+23

Response time1 day
Response rate100%
Recommended by100%of homeowners
...
Showing 1-10 of 110
Masonry FAQs, answered by experts

You will repoint over a fraction of the old mortar, but you should scrape away 1/2 to 1 inch of mortar from the joints before repointing. Otherwise, the repointing is only masking the weakened mortar instead of actually replacing it, which could put your chimney at risk of bigger, more expensive damages later on.

It is possible, albeit a lot slower, to break up a rock using water. You would do this by freezing and thawing the water. You could create some initial holes or cracks in the rock, then pour water into the cracks or holes and allow them to freeze (so it's best to do this in winter or in colder climates). Since water expands when it freezes, this puts pressure on the inside of the rock and causes it to crack. You could continue to pour more water in and let it freeze to continue to break up the rock.

You can turn a red brick white through a process called whitewashing. Whitewash isn’t a stain but rather is made from water and white latex paint. Adding more water to the mix will make the solution look lighter when applied, and adding more paint will make it look more white.

Mortar, or masonry mortar, is mainly used in joints and as parging for stone, brick, or cement construction. Stucco is primarily a surface material used as wall coverings. For maintenance, masonry will need repointing or replacing as damage or land shifting occurs, whereas stucco will need patching or refinishing as it tends to crack over time along with other types of wear-and-tear.

The cost to install or replace brick or stone siding generally ranges from $10 to $50 per square foot. The final price depends on several factors, including the specific material type, local labor rates, and any necessary preparation work, such as removing old siding. For example, different types of stone have varying costs per square foot: natural stone ($4.50–$35), stone veneer ($11–$13), faux stone ($6–$9), and cultured or manufactured stone ($5–$8).

The Sulphur, LA homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.