Top-rated masons.

Get matched with top masons in Ponchatoula, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your masonry work project in Ponchatoula, LA?

Select your specific project to find the pro for you.

TRUSTED BY PONCHATOULA, LA HOMEOWNERS

  • Average homeowner rating star icon4.9
    Average homeowner rating
  • Verified reviews icon19
    Verified masonry services reviews

Find Masons in Ponchatoula

Avatar for About All A+ Yardwork, LLC
About All A+ Yardwork, LLC
4.6(
107
)
Foundation Drainage - Install or ReplaceBasement Drainage Channels - Install

Serving Ponchatoula, LA and surrounding areas

Approved

In business since 1979

Free estimates

Emergency services offered

"I would highly recommend About All A+ Yardwork. I had a drainage issue in my side yard and not only is this problem solved but his bid was very reasonable for the amount of work done. Once the job was completed it looked like this was always there. I will recommend him to all of my friends and neighbors for any landscaping work they may need. I would hire him again without any reservations."
Relevel regarded work
Relevel regarded work
Relevel regarded work
Drainage work
Drainage work

+62

Response time10 hrs
Response rate96%
7 neighbors recently requested a quote
Avatar for J&S Plumbing
J&S Plumbing
4.9(
60
)
Basement Drainage Channels - Install

Serving Ponchatoula, LA and surrounding areas

Approved

Super Service Award Winner

In business since 2016

Emergency services offered

Credit card accepted

"They did a wonderful and professional job from start to finish. They were prompt informative and cleaned up The clean up made them stand out even more. They replace my entire water line from the kitchen and laundry room. Also replace part of the main sewer line Replaced the bricks and concrete I highly recommend J n S Plumbing"
Plumbing Project
Plumbing Project
Plumbing Project
Plumbing Project
Additional Photos

+14

Response time1 day
Response rate100%
1 neighbors recently requested a quote
Avatar for AD Remodeling LLC
AD Remodeling LLC
New to Angi
Brick or Stone Siding: Repair or Partially ReplaceBrick, Stone or Block Wall - RepairBrick and Stone Flatwork - Repair+2 more

Serving Ponchatoula, LA and surrounding areas

Approved

AD Remodeling LLC have been serving customers for almost 10 years .We have worked in the state of Florida and now in Louisiana. We care about the customers satisfaction and we also care about quality work . We look forward to working with you.God Bless

Bathroom remodeling
Bathroom remodeling
Bathroom remodeling
Bathroom remodeling
Bathroom remodeling

+28

11 neighbors recently requested a quote
...
Showing 1-10 of 192
Masonry questions, answered by experts

You may not need a hammer drill if you’re planning on drilling one or two very small diameter holes in brick. For holes with a diameter of 3/16-inch or less, a regular drill with a masonry bit can do the job. However, the bit will heat up quickly, and the process will take significantly longer than with a hammer drill. Prepare to cool your drill bit down in a bucket of water more often.

Mortar is a mixture of sand and cement that binds materials, such as bricks, stones, and concrete blocks, together. Think of it as the glue that fills in the gaps between bricks and stones, then seals them in place to prevent damage or deterioration. Mortar also helps spread the load across a wall or structure, keeping cracks and shifting at bay.

You can turn a red brick white through a process called whitewashing. Whitewash isn’t a stain but rather is made from water and white latex paint. Adding more water to the mix will make the solution look lighter when applied, and adding more paint will make it look more white.

Yes, you can limewash surfaces other than brick. Plaster, stone, stucco, and concrete can all also be limewashed. Any porous surface that will absorb the wash is a good candidate for limewash, although it won’t help much with waterproofing. If you choose to limewash over paint, you’ll need to prep before applying it to avoid a powdery, chalky finish. Shiny surfaces like metal or glass can’t absorb limewash, so it’s not suited for these.

It’s called cobblestone because it’s made of stones that are “cobbed” together. A cob is a term that refers to rounded lumps. Originally, cobblestone streets were made from pebbles and stones gathered from riverbeds that had been rounded over time by the passage of water. The term has nothing to do with a cobbler, which is the term for someone who makes and fixes shoes.

The Ponchatoula, LA homeowners’ guide to masonry services

From average costs to expert advice, get all the answers you need to get your job done.