Get matched with top sink installation pros in Versailles, KY

Yes, you can use flexible pipe for a sink drain. Flexible pipes can make it easier to fit sink plumbing together with less measuring and fewer cuts. However, corrugated flexible pipe can trap hair, grease, and food particles in the folds and cause foul odors and eventually build up enough to clog the drain. Smooth pipes are recommended for sink drains and plumbing.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Yes, plumber's putty ensures a solid bond between the drain assembly and sink. Silicone is a good alternative if you prefer not to use plumber's putty. However, plumber's putty typically isn't visible from the outside of the drain, as you can wipe away any excess when done.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.