Get matched with top fencing pros in Tompkinsville, KY

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

Most homeowners don't need to inform their neighbors before constructing a fence, according to the law, but you will need to make sure that you’re building on the property line or on your side of the property line. Otherwise, the neighbor could complain, which would require you to tear down and reinstall the fence. In any case, keeping them in the loop is the neighborly thing to do!

Whether you inform your neighbors or not, always use property records and a land survey to ensure your fence stays within your property boundaries.

Maintain your wattle fence by inspecting it at least twice per year for loose weaving and degrading branches. Replace any seriously degraded sections, ensure water drains properly around the posts, and trim any sprouting branches if you used green wood. If you notice the weave loosening, you can often tighten it by gently pushing down on the top branches. You can also apply a natural wood preservative every two to three years to extend the fence's lifespan.

In most cases, you will need a building permit to put up a vinyl fence, especially if the fence is sitting on or close to your property line. You can ask your local building department or  fence installation company if your fence project will require a permit. If so, you can expect it to cost between $20 and $60. Your fence installer should pull the permit for you. Building without a permit could eventually require you to pay again to remove the fence and reinstall it after getting the job approved.