Get matched with top fencing pros in Piper City, IL

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

Black chain-link fences last an average of 15 to 20 years. The thicker a fence's wire gauge, the longer it will tend to last. The black vinyl coating gives the fence rust and corrosion resistance, but its life span may be lower in wet, humid, or coastal climates where moisture or salty air can corrode the coating more quickly.

Whether you need a permit to build or install a fence depends on several factors, including your location, the fence's height, its placement in your yard, and the materials used. In many cities and highly populated areas, a permit is required, especially for fences taller than 6 feet. Conversely, rural areas may have fewer restrictions. Typically, backyard privacy fences 6 feet or shorter do not require a permit, while front yard fences often have a lower height limit, sometimes as low as 3.5 feet. There can also be exceptions for properties in mixed residential-commercial zones. It's best to check with your local building inspection or zoning department to understand the specific requirements, height restrictions, and location rules for your area. A professional fence installer can help you navigate this process and often secure the necessary permits for you, though this may extend the project timeline.

Pallet fences come with built-in support through the fence posts you should install on each side of their vertical interior. Stand the fence upright and slide it onto the fence posts, then further support it with 2x4 wood boards that you drill across each point where two pallets connect side-by-side.