Get matched with top deck maintenance specialists in Nampa, ID

Before installing a new railing, check the condition of the deck frame and joists, especially around the perimeter where posts attach. If boards are loose, soft, or show signs of rot, the structure may need repair. A deck pro can inspect your framing to confirm it meets load-bearing requirements.

It is recommended to clean your deck once or twice a year to prevent the accumulation of dirt, debris, mold, and mildew. The ideal times for cleaning are in the spring and fall. A spring cleaning removes grime that has built up over the winter, preparing your deck for summer use. A fall cleaning washes away messes from summer activities, preventing them from setting into the wood over the winter. The exact frequency can depend on factors such as how often the deck is used, its exposure to pollen, and whether salt was used on it during the winter. Regular cleaning helps protect the wood and its finish from damage.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.