Top-rated concrete cutting pros.

Get matched with top concrete cutting pros in Lansing, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete cutting project in Lansing, IA?

Select your specific project to find the pro for you.

Find Concrete cutting pros in Lansing

Avatar for American Waterworks
American Waterworks
4.5(
171
)
Concrete Flatwork - Repair & Resurface

Serving Lansing, IA and surrounding areas

Approved

In business since 1989

Free estimates

Warranties offered

"They did great. The entire surface was level and free from tripping hazards. It is important to have them seal the cracks because there will be water from snow melt and the concrete will move. This will get you the 5 yr warrantee just in case."
Another Sinking Floor
Dirt Crawlspace in Elk Mound, WI
Concrete stoop had sunk over 6 inches
Foundation Failure Signs
Increased Efficiency of Crawlspace in Elk Mound

+156

Response time4 hrs
632 neighbors recently requested a quote
Recommended by91%of homeowners
RCG Construction LLC
5.0(
1
)
Concrete Flatwork - Repair & Resurface

Serving Lansing, IA and surrounding areas

In business since 2023

Free estimates

Offers commercial services

"Well-spoken. Hard working. They tell you what they will do and when. And that's exactly what they do. They went over and beyond to make sure we had an attractive, long-lasting garage floor. They know concrete and they know what tools to use. I know our job had a big surprise. When they started to remove the old floor, they found another floor underneath. We had no idea. It caused them more work in the prep, but they didn't balk or hesitate or ask for more money. I wish we had more work for them, but we don't. Absolute certainty that, if we ever need any concrete work in future, this is who we'll call. A"
Response time8 hrs
Recommended by100%of homeowners
Concrete Cutting questions, answered by experts

This all depends on the tools you have on hand and whether you’re trying to cut a straight line or shapes. 

The best tool to use for straight lines is either a circular saw or table saw. When cutting shapes, a jigsaw will be the easiest and most precise tool to use. 

Professional metal fabricators typically charge around $70 per hour, but the total cost of your project will depend on several factors. The largest cost drivers are the size, complexity, and design of the project, as well as the price and type of metal used. A good way to estimate the total cost is to multiply the cost of raw materials by four; typically, one-quarter of the total goes toward materials and three-quarters toward labor. Your geographic location can also influence costs, as labor and material prices vary by region.

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

Yes, you can cut up a box spring., but you’ll need to do so in layers. You can clear the fabric and fluff away to reveal the springs before removing them as well.

There are a few things you can ask welders before you hire them to get an idea of their experience and ability levels:

  • Are you licensed and certified?

  • How long have you been in the welding business?

  • Do you commonly do the type of welding I need?

  • Do you offer any kind of warranty for your work?

  • Do you charge by the hour or by the project?

  • How long do you expect my welding project to take?

  • What steps do you take to minimize errors in your work?

The Lansing, IA homeowners’ guide to concrete cutting services

From average costs to expert advice, get all the answers you need to get your job done.