Get matched with top percolation testing pros in Allenhurst, GA

According to the Environmental Protection Agency (EPA), you should contact the following officials to report a case of asbestos exposure:

• Asbestos subject matter experts in your state 

• EPA regional office

• Toxic Substances Control Act (TSCA) Assistance Information Service Hotline via mail, email, or phone

• EPA’s Asbestos Ombudsman via phone or fax 

While asbestos can’t be directly absorbed through the skin—the fibers are too big—skin contact can still produce symptoms. Contact dermatitis can flare up in sensitive individuals but in most cases, the danger from asbestos comes from inhaling the fibers, or dust, that is produced when asbestos is disturbed. If you touch asbestos by accident, immediately wash yourself and your clothes.

Unlike some home problems, such as water damage or pest infestations, asbestos can be very difficult to spot. Asbestos is a mineral in the form of microscopic fibers and was previously used in building materials for its bonding and fireproofing abilities. Insulation, roof shingles, ceiling tiles, floor tiles, pipe wrappings, soundproofing materials, and textured paint features like popcorn ceilings are common sources of asbestos, particularly in homes built before 1980.

Age is perhaps the biggest indicator of asbestos, as legislation passed in the 1970s labeled asbestos as dangerous and regulated its use in building materials. Signs of age in the form of wear and tear or material degradation are also indicators that asbestos fibers may be leaking into the air, but ultimately, it’s difficult to detect with the naked eye. If you have reason to suspect asbestos in your home, it’s best to hire a certified asbestos inspector.

Epoxying over asbestos tiles is generally considered a safe option when done correctly. Epoxy acts as a sealant, encapsulating the asbestos tiles and preventing the release of asbestos fibers into the air. The key is ensuring that the asbestos tiles are in good condition, firmly adhered to the substrate, and not damaged or deteriorating. This method is only appropriate for tiles that are undamaged and securely in place. If the asbestos tiles are already loose, damaged, or deteriorating, encapsulating them with epoxy may not be a sufficient solution, as it might not address the potential for ongoing asbestos exposure.