Get matched with top sink repair pros in Wright, FL

Most faucets come with a rubber or plastic gasket that prevents leaks—but that’s not always the case. If your faucet doesn’t come with a gasket or it’s leaking, use a caulk gun to seal the gaps and prevent water damage.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

There are few things more annoying than trying to fall asleep only to be woken up by the sound of a dripping faucet. If the faucet drips when the water is off, it probably has a loose or damaged seat washer. The screw gets loose from repeated use, making the faucet drip. With outdoor faucets, this is more common in the summer when people are using it more often to water the garden or cool off. Disassembling the faucet and tightening or replacing the seat washer and screw can get the dripping to stop.

While unplugging your garbage disposal and plugging it back in may help, most units have an actual reset button, a bright red switch found on the underside of your unit. If your garbage disposal needs resetting, you may notice this button sticking out about a quarter of an inch from the surface of the unit, with which it’s usually flush. Simply depress this reset button to reset the unit, and then test to ensure it’s working about 10 minutes later.