Get matched with top sink repair pros in Steinhatchee, FL

Yes, you can replace just the top of a bathroom vanity, which you may choose to do if you love the look of your vintage bathroom cabinets, but the countertops are not your style. Fortunately, it is pretty simple to detach a vanity top from a base for replacement, but you should still shut off the water to avoid a leak. Replacing only the vanity top costs around $400 to $4,300.

There are several types of sink drain stoppers, including pull-out, twist-and-pull, and pop-up. Pull-out sink stoppers can be removed by pulling on the stopper until it comes out of the drain. A twist-and-pull design requires lifting then turning the stopper to lock it in an open position and the opposite action (turning, then pressing down) to close it. A pop-up sink stopper works by pushing down the drain cover to open or close the passageway. 

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.