Top-rated concrete driveway pros.

Best concrete driveway pros near O Brien, FL

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete driveway service project in O Brien, FL?

Select your specific project to find the pro for you.

Top-Rated Concrete driveway pros in O Brien - Updated Nov 2026

Avatar for Wells Asphalt Paving
Wells Asphalt Paving
4.9(
19
)
Asphalt Paving - Install

Serving O Brien, FL and surrounding areas

In business since 1978

Free estimates

Warranties offered

"Wells Asphalt Paving did a great job! One day to tear out the old driveway and put in new gravel base, then a few days later laid the new asphalt. Efficient, explained things well and most important, did a great job at a reasonable cost. The neighbors are already commenting on day one!"
Driveway
Driveway
Parking lot
Driveway
Response time3 days
Recommended by100%of homeowners
Showing 1-10 of 46
Concrete Driveways FAQs, answered by experts

Pressure washing your driveway can prevent cracks in it since it removes grease and oil, which, if left on the driveway for too long, can break down compounds in concrete and asphalt, leading to cracks. It can also help keep driveway weeds, moss, mold, and mildew at bay while boosting your home's curb appeal. 

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

No. In spite of its identical chemical makeup, sodium bicarbonate manufactured for blasting purposes has a particular type and size of particles that differs from grocery store baking soda. In addition, this method would not be cost effective because you would need several boxes of baking soda to equal one blast-sized bag of medium.

Periodic sealing and cleaning to maintain appearance and integrity.

The O Brien, FL homeowners’ guide to concrete driveway services

From average costs to expert advice, get all the answers you need to get your job done.