Get matched with top pressure washers in Mango, FL

You should avoid using a pressure washer on any surface or item that could be damaged by the high-pressure spray, as some materials are too delicate to withstand the force.

Key items and surfaces to avoid include:

• Electrical Components: Never pressure wash electrical systems, as water can cause short-circuits and create a safety hazard. This includes utility meters, breaker boxes, electrical outlets, generators, and HVAC or air conditioner units.

• Delicate and Fragile Materials: Fragile items can crack, shatter, or be stripped by the pressure. Avoid pressure washing windows, glass, light fixtures, shingled roofs (especially asphalt), and stucco.

• Painted, Stained, or Sealed Surfaces: Unless your goal is to strip the finish, do not pressure wash painted surfaces, stained wood (like decks), or anything with a protective seal that could be stripped away. Be especially cautious with older surfaces that may contain lead paint.

• Soft Woods and Certain Decking: Delicate surfaces like softwood, composite decking, and antique or wooden patio furniture can be etched or damaged. If you must wash wood, use a lower-powered pressure washer with a wide-angle nozzle to prevent damage.

• Living Things: Never use a pressure washer on people, pets, or plants. The force can cause serious injury and will destroy landscaping.

These parts of the house are okay to pressure wash:

• Natural wood decking that is not stained or painted

• Siding made of vinyl, aluminum, and cement

• Concrete

• Most children’s toys

• Outdoor furniture

• Trash cans and recycle bins

If you’re using water pressure above 2,000 PSI, you should wear a full face shield—at 4,000 PSI, a water jet can easily slice through skin. Always wear heavy-duty, waterproof gloves and rubber boots with metatarsal guards. If you’re working with hot water, make sure your gloves are insulated.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.