Top-rated lighting pros.

Get matched with top lighting pros in Wasco, CA

Enter your zip and get matched with up to 5 pros

Need a pro for your lighting service project in Wasco, CA?

Select your specific project to find the pro for you.

Find Lighting pros in Wasco

No results for Lighting pro in

Try adjusting your search criteria.
Lighting questions, answered by experts

No, you should not leave LED Christmas lights up all year. While the LED lights themselves are very durable, their wiring and casings can be as vulnerable as any Christmas lights. They’re subject to drying out, experiencing cold or sun damage that causes them to crack, and even damage caused by gnawing pests. (The same is true of incandescents.) If you want your lights to last the years that they’re rated for, bring them inside after Christmas is over. 

The five common types of landscape lighting are up-lighting, down-lighting, spotlights, built-in lighting, and pathway lighting.

  • Up-lighting casts light upwards from the ground, mostly for aesthetic purposes.

  • Down-lighting directs light onto the ground, lighting pathways, or outdoor space.

  • Spotlights cast direct, focused lighting in any direction.

  • Built-in lighting integrates lighting into an outdoor feature.

  • Pathway lighting illuminates walkways, increasing safety.

Table lamps, floor lamps, chandeliers, desk lamps, and antique or decorative light fixtures that hold sentimental or aesthetic value are commonly repaired.

Pool lights are designed to be safe by protecting swimmers from electrocution. These lights are made with waterproof fixtures and seals to prevent contact with the water.

Electrocution from pool lights is still possible, but rare. Faulty wiring or broken lighting equipment can make lights unsafe, so it’s important to replace lights as needed and have an electrician inspect and upgrade the wiring.

If half of a string of Christmas lights is out, it is likely because of a single burned-out, loose, or broken bulb within that section. Long strands of lights often contain more than one circuit, so when one bulb fails, it can cause the entire circuit (or half the strand) to go dark. To fix this, inspect the unlit section and test each bulb to ensure it is tight and functioning properly. Replacing the faulty bulb or repairing a damaged shunt will typically solve the problem.

The Wasco, CA homeowners’ guide to lighting services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"