Best pressure washers near Salida, CA

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.

It’s not necessary, but you can absolutely use soap or detergent when pressure washing your house. Washing with a mixture of soap and water will ensure your siding is spotless when you’re finished. However, in many cases it is not necessary to use soap and you can still achieve a powerful result without any product.