Get matched with top concrete resurfacing pros in Prather, CA

Routine cleaning with light detergents, avoiding abrasives, and timely addressing chips prolong the new surface appearance.

Yes, adding a patio or other concrete feature can increase your property taxes, particularly if it's considered a permanent improvement. The general rule is that if the project requires a permit, your property taxes will likely go up.

Permanent structures like a poured concrete patio are considered capital improvements that require a permit, which will trigger a reassessment of your property's value. Other concrete projects that typically increase taxes include:

• Pool decks

• Walkways

• Driveways

• Steps

• Foundations

In contrast, 'temporary' installations, such as a paver or flagstone patio, may not require a permit and are less likely to affect your property taxes.

Permit costs for a concrete patio can range from $75 to $200. While the tax increase varies based on your location and the project's size, it is often a minimal amount. Always contact your local building department before starting a project to confirm permit requirements and any potential impact on your taxes.

The method used to repair cracks in your concrete driveway will depend on the extent of the damage, but the most common method for small cracks is to use a driveway resurfacing compound. This solution is either cementitious or made of polyurethane, and it will seal the crack and make your driveway appear undamaged. 

For more severe cracks, you will likely need to hire a professional driveway repair service. They can use mudjacking, epoxy injections, partial driveway replacements, or a combination of these to fix more serious cracks in your concrete driveway and to prevent recurring issues.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.