Get matched with top deck maintenance specialists in Porterville, CA

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

There are approximately 5.33 board feet in a 2x4. You can use the board foot calculator in this article to easily find the answer. A 2x4 is 2 inches of thickness by 4 inches of width, so you need to find the length, with 8 feet being the most common. You’d use the calculator here to multiply 2 times 4 times 8, and then divide by 12, arriving at a total of 5.33 board feet. 

Deck skirting shouldn’t touch the ground, especially if you have a wood deck, which is vulnerable to moisture. Ideally, you should leave at least 3/4 of an inch of space between the deck skirting and the ground for more ventilation. Pros also recommend that you incorporate about 1 square foot of space for ventilation for the underside of the deck to every 150 square feet of decking. Proper ventilation prevents mold growth and rot that can damage your deck.

Local building codes don’t specify the number of steps a deck can have before a railing is required, mainly because stair height varies widely. Most areas require decks 30 inches or higher to have a railing. While not exact, that roughly equates to four to seven steps.